Snigel - stringer foam blaster

Nerf style blaster with matching holster and dart holder. Uses Elite half-length darts. Single bullet, string powered, top-loading.

All parts are printable except the string, use a 4-3mm bungee coord. The blaster use one of each model that are not marked with "extra"

The magazine and holster both use a clip and clip pin.

All parts are pre-oriented, and use friction fit, the back sight might need a drop of glue.

Snigel is Swedish for "snail".

BLASTER PRINT SETTINGS
I use the same settings for all parts:
- Outside in.
- 0.15mm lay height.
- 10% support with 70% angle.
- Brim (extra large on body).
- 3 wall lines.

HOLSTER & MAGAZINE PRINT SETTINGS
- 0.25mm lay height.
- A lange Brim.

NOTES
The darts will jam if they are too soft from long usage.
If you get jams, try loosen the string a bit.
Don't leave the darts in the holder for a long time.

EXTRA CREDITS
I took a lot of inspiration and design choices from these two creators:
LeedleDynamics
https://