Snowflake light

A simple Snowflake light I created. I used a particular circuit kit from Kitronik and made the holes and clips for it the best I could. If you print the lid part with supports it will probably make the clean up of the prongs that hold the circuit board have an easier fit. For this model I just glued the back to the front.Print Settings Rafts: No Supports: No Resolution: 0.2 Infill: 100 The circuit I used was this one https://kitronik.co.uk/products/2161-micro-usb-lamp-kit-1w-led-v20?variant=31813751799871