Thingiverse
Socket wrench insert Holder
von JuraJS
20
Downloads
18
Likes
0
Makes
Socket wrench insert Holder
I designed and created Holder for MATADOR Socket wrench insert 1/2"
long External hex 10mm 11mm 12mm 13mm 17mm.
- for MATADOR Socket wrench insert 1/2"
long External hex 10mm 11mm 12mm 13mm 17mm
printed parts, material PETG:
The printing orientation must be observed as show photo!
(the design of the part is created with regard to the printing orientation)
[layer height=0,20mm][Infill=30% Grid][vertical shells perimeters=2]
JS_HolderSocketwrench_10-11-12-13-17
Tip:
If necessary for tune the optimal tightness of the socket hold, if loosely then drop of superglue (creates a bump), then the Socket hold not too tightly or loosely.
I designed and created Holder for MATADOR Socket wrench insert 1/2"
long External hex 10mm 11mm 12mm 13mm 17mm.
- for MATADOR Socket wrench insert 1/2"
long External hex 10mm 11mm 12mm 13mm 17mm
printed parts, material PETG:
The printing orientation must be observed as show photo!
(the design of the part is created with regard to the printing orientation)
[layer height=0,20mm][Infill=30% Grid][vertical shells perimeters=2]
JS_HolderSocketwrench_10-11-12-13-17
Tip:
If necessary for tune the optimal tightness of the socket hold, if loosely then drop of superglue (creates a bump), then the Socket hold not too tightly or loosely.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
