Thingiverse
Sofirn LT1 lantern base
di Cymond
2
Download
2
Likes
0
Makes
This is a simple base for the Sofirn LT1 lantern. It expands the base to approximately 4 inches to help reduce tipping.
You'll need a 1/4x20 screw (1/2 inch long) and a hex nut. Inset the hex nut from above, tighten the screw from below, and then twist the whole thing onto the base of the lantern. It is designed to easily twist on and off.
I printed mine in "natural" PLA on the bottom and black on top. I chose "natural" because it is translucent.
No supports needed. I also make the design public on Tinker for those who want to edit it.
You'll need a 1/4x20 screw (1/2 inch long) and a hex nut. Inset the hex nut from above, tighten the screw from below, and then twist the whole thing onto the base of the lantern. It is designed to easily twist on and off.
I printed mine in "natural" PLA on the bottom and black on top. I chose "natural" because it is translucent.
No supports needed. I also make the design public on Tinker for those who want to edit it.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
