MakerWorld
Garden
Go to Model
Soil Moisture Sensor
18
Downloads
12
Likes
12
Makes
This is a two part project for soil moisture sensors for your garden. Plate 1 has the parts for the housing that holds an ESP8266 [link], BME 280 temperature and humidity sensor [link] and a receiver for the resistive sensors (included with the sensors, see next link). Plate 2 contains the housing for the sensor itself [link]. This model uses these bike fittings to seal the part where the cables are fed to the sensor. The sensors are connected by simple cables with the receiver board and the ESP. The ESP itself can be connected e.g. to HomeAssistant.
ueda also publishes on
134 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
