Thingiverse
Solder spool holder
door clayrev
48
Downloads
26
Likes
1
Makes
1 lb solder spool holder. (Kester brand 0.02" dia; I haven't tried any other ones) Add some of those sticky feet things https://www.amazon.com/Black-Rubber-Feet-Stick-Bumper/dp/B06XPFDQBH
Use more infill if you think you will be rough with it, I went with 25% on the base and 40% on the spindle for V1, 1.2mm thickness, 0.2 layer height.
V2
Made it 5mm less wide, put a hole in the spindle. Added a hawse (for under-wind). Need support for this unless you are really good at bridging. Spindles will not interchange.
V1
19.2mm spindle for spool hole of 19.5mm.
Width is 65mm on the inside, probably get a 64mm wide spool in there
no supports required, probably want a brim on the spindle.
Choose your desired infill. I used 25% for the base and 40% for the spindle.
PM me if you have a different size hole in your spool, I can make new files.
Use more infill if you think you will be rough with it, I went with 25% on the base and 40% on the spindle for V1, 1.2mm thickness, 0.2 layer height.
V2
Made it 5mm less wide, put a hole in the spindle. Added a hawse (for under-wind). Need support for this unless you are really good at bridging. Spindles will not interchange.
V1
19.2mm spindle for spool hole of 19.5mm.
Width is 65mm on the inside, probably get a 64mm wide spool in there
no supports required, probably want a brim on the spindle.
Choose your desired infill. I used 25% for the base and 40% for the spindle.
PM me if you have a different size hole in your spool, I can make new files.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
