Soldering spool Holder

Soldering Spool Holder Info


1-Print All Parts

2- Find a used Blade From an exacto or any other blade from a disposable Blade knife.

3- Bring down the blade to about 10 mm and if you have the dexterity make it a triangle shape (be careful not to hurt yourself)

4-Use a scalpel or any other knife you do not mind heating the tip of it and after heating it, you use it to make a cavity that will receive the blade that you have prepared.

5-Insert the blade and use some glue to fix it there (I used Kafuter UV Glue, you can get some from EBay and also the UV Flashlight)

6-you will need to sand just a bit the shaft from Shaft "B" to have a snug fit, for those who wonder why I made a groove and slut in Shaft "A" ,it is to make it easier to assemble both shaft together as there is no air pressure staying inside ...

7-To use take as much solder as you need then hold the spool and pull down the solder on the Sharp edge of the Blade... Careful again not to put