Thingiverse
Solid Can Opener Handle
von timprint
0
Downloads
1
Likes
0
Makes
This is a press on handle to replace a broken handle from a cheap can opener.
The factory can opener has small tabs that make a very weak connection point.
This one is solid and a tight fit. print at 100% and press/pound onto the can opener.
The gears will drive into the PLA. No need for adhesive of any kind.
Thanks
The factory can opener has small tabs that make a very weak connection point.
This one is solid and a tight fit. print at 100% and press/pound onto the can opener.
The gears will drive into the PLA. No need for adhesive of any kind.
Thanks
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!