Solidoodle 2 Wire Bundle Management Things

This was originally inspired from fredhag's wire guide that was made for a Solidoodle 3. I tried that guide and found that it just wasn't low enough for my wire bundle. I started a new one from scratch and dropped the overall design down further and added a more rounded slope.

After making the wire guide, I found that I still had issues with the wire bundle drooping and rubbing on the x-axis belt when the print head was roughly in the middle of the print surface. By simply manually holding the back end of the wire bundle up I found that the wire bundle had enough clearance to not rub on the belt. So, I made a little piece that'll hold the back of the bundle up and help with drooping wire clearance against the x-axis belt. For me, there seems to still be enough stretch to make it to the far corner with no problem.

After making the wire bundle holder, I ran into another problem. While my wire bundle was no longer rubbing the belts, it was coming too close for comfort near the