Thingiverse
Somewhat more parametric self watering pot insert
por CarlCarlsonBoi
2
Descargas
2
Likes
0
Makes
*NOT my original desing. This is merely a slight adjustment to this desing by DanLab (https://www.printables.com/model/62156-customizable-self-watering-planter-insert-for-roun#_ga=2.196641198.386464283.1667298054-2136257917.1664315092) to make it slightly more customizable.
I needed to make my design 230 mm wide on the top, and in the original design there were some constraints related with the funnel that would cause problems. Adjust to your liking! The model is also split in order to print in two pieces if it is too big for your printer.
How to do it: you need Fusion 360, open the file and modify the parameters to your liking. Probably some warnings will appear, but it should be fine. Double check that the funnel is not blocked!
For more details and instructions, go to the original poster post.
I needed to make my design 230 mm wide on the top, and in the original design there were some constraints related with the funnel that would cause problems. Adjust to your liking! The model is also split in order to print in two pieces if it is too big for your printer.
How to do it: you need Fusion 360, open the file and modify the parameters to your liking. Probably some warnings will appear, but it should be fine. Double check that the funnel is not blocked!
For more details and instructions, go to the original poster post.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
