Sonic Pad Bracket/Mount

This bracket was designed for an enclosure with 12.7 mm thick plexiglass. The hardware used is seen below:

1) M8 x 50 mm for mounting to enclosure
2) Washers for mounting to enclosure
3) M3 x 15 mm for mounting to sonic pad

I printed this with the ender 3 S1 pro. I used the following settings:

1) Infill pattern: Gyroid
2) Infill percentage: 20% (Can do more for strength)
3) Travel speed: 120 mm/s
4) Support material: Yes
5) Nozzle Diameter: .6 mm
6) Extruder temperature: 240° C
7) Bed temperature: 80° C

NOTE: This bracket can be used with other enclosures, but the hardware for the bracket will change.