Thingiverse
Source4 Barrel Knob Socket
von joblight
36
Downloads
34
Likes
0
Makes
Socket adaptor for barrel knob thumb screw on an ETC Source Four.
This was designed for use on a 1/4" x 3/8" square drive drill adaptor but could work with any 3/8" drive socket wrench. When using a drill, make sure the torque clutch is set to it's lowest possible setting.
This was designed for use on a 1/4" x 3/8" square drive drill adaptor but could work with any 3/8" drive socket wrench. When using a drill, make sure the torque clutch is set to it's lowest possible setting.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
