MakerWorld
Other Fashion Models
Model downloaden
Space Invaders Drawstring beads
99
Downloads
141
Likes
56
Makes
Comes with a T-bar to remove the supports.The hole is 5 mm, so it should fit most drawstrings. The easiest way to put them on is to twist the model while pushing the drawstring down.Only 3 grams per set.Supports are needed only on two of the models.Infill: 15–20%.PLA
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
