Thingiverse
SpaceX Magnetic Patch mount
von TheSpaceEngineer
1
Downloads
0
Likes
0
Makes
The hooks are a little tricky to print, so be sure you have a well-calibrated machine. Should be in the right scale for POST-IFT1 SPACEX PATCHES.
BIG NOTICE;
SpaceX changed the width of the patches halfway through production of patches for IFT1. Please make sure to measure your patches. This should fit the now standard size of 3.5in across. Some of the first batches of IFT-1 patches are around 4in and will not fit this bracket.
This is very much a half-assed project but it works and people requested it to be released. May change if SpaceX changes the shape of the patches
MAGNETS!!: This works with 10mm by 2mm magnets of any kind.
BIG NOTICE;
SpaceX changed the width of the patches halfway through production of patches for IFT1. Please make sure to measure your patches. This should fit the now standard size of 3.5in across. Some of the first batches of IFT-1 patches are around 4in and will not fit this bracket.
This is very much a half-assed project but it works and people requested it to be released. May change if SpaceX changes the shape of the patches
MAGNETS!!: This works with 10mm by 2mm magnets of any kind.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
