Thingiverse
SpaceX
door Ejectkid
14
Downloads
13
Likes
0
Makes
I found this on PrusaPrinters site. It wasnt tall enought for me, so I ran it through fusion. You'll have to figure out a way to run with no top or bottom layers to get the infill to show. Enjoy!!!
https://www.prusaprinters.org/prints/88-spacex-landing-pad
https://www.prusaprinters.org/prints/88-spacex-landing-pad
Ejectkid publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
