Spacing Tool

This divider allows equal spacing and centering of parts. I made this to help with centering of my kitchen cabinet hardware.

To make the most simple (2 points, not that useful) you need:
4 caps
2 short tops
1 bottom long 2 connector
1 bottom short

For each additional point print an additional:
3 caps
1 top long
1 bottom long

The one in the picture has 7 points and expands to 35 inches/890 mm it needed:
19 caps
2 short tops
5 long tops
1 short bottom
1 long bottom 2 connector
5 long bottoms

To assemble, put the divider together upside-down to how it was shown in the picture and put a drop of CA glue on each hole in the back. Don't use the Loctite super glue, it took way too long to dry.