Spamfer mag remix

Here's a remix i made of the wonderful spamfer mag that was created by N_G! I have changed a few things to my personal preference:

- Redesigned follower to maintain pressure on the last dart (I believe N_G has implemented this on his newest version too)

- New baseplate design which secures without glue. You just need to clip it in and put a piece of filament through the hole, which locks the body and base together

- Added a hole in the follower to put the cut end of a talon spring into, so that there is no chance of it getting trapped between the walls of the follower and body

Parts should be printed in the same direction as the original spamfer mag and it takes roughly 5 hours and 30g of filament to print one full mag.

You will need a talon spring that has been cut down into thirds, but I am also working on a variation that uses round springs from ebay which should be cheaper and easier to source.

This mag will also fit into the Lynx nicely