Speaker stand

This is my first design and frankly my first serious print, that's why it isn't perfect.

What do you need:
- 3x cap
- 3x dowel_short
- 1x base_bottom and base_top
- 1x stablilizer (for each level, it goes between pillars)
- 3x pillars for each level (pillar height 15.5cm/6.1in)
- 3x dowel_long (for each level, and exta 3 to mount base)
- glue (if you printing in abs something like UHU might be perfect choise)

Important - dowel_long might need scaling up or down, depending from material you printing in. Print just one or two and check if they fit.

How to assembly:
- 3x glue dowel_long to base_bottom
- 3x glue pillar
- glue stabilizer
- 3x glue pillar
- repeat until required height is reached
- 3x glue dowel_long
- glue base_top
- 3x glue dowel_short
- 3x glue cap

Printing tip:
As I mentioned this was one of first prints so I make couple mistakes, one of which was wall thickness. I printed it in 0.8 which is not enough. Maybe 3 or 2 would be sufficient enoug