Sphynx cat

Picture source/author: @hanzo.ai.art / HanzoAI Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.   Model is 150x200 mm in size. Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. You may print at higher layer heights below the Min Depth of 0.4mm. The Max Depth is 2.2mm and the Actual Depth is 2.2mm It is possible to print without ACE by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. Filaments Used: PLA Elegoo+ Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Orange Transmission Distance: 4.8 PLA Elegoo + White Transmission Distance: 6 This print uses 4 unique filaments Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Blue Gray At layer #10 (0.88mm) swap to Orange At layer #15 (1.28mm) swap to White for the rest.