Spider-Man Faceshell

NOTICE: Credit is given to RooShoo and link to their project is https://www.thingiverse.com/thing:5266398 Print everything without supports EXCEPT the lens frames. The face shell and lens includes holes for round circular magnets, of the following sizes.4x of 6mm4x of 8mm Trim mesh into the lens clips as needed.Sand down the face shell for comfort. All sticking was done with Gorilla Glue, but can be done with any type of super glue. There is a red mask over the shell. I will do the black web designs later with black fabric glue or hot glue. I had a lot of trouble when printing because of the holes, so MAKE SURE ADHESION IS ON. This will save you a lot of filament, trust me. If you are trying to save filament, don't print “spiderman_1_head_2_opt”. It is not extremely necessary, but would be nice and snug to have. Good luck and ask questions!