Thingiverse
Spill Proof Oil Can
von zerocorebeta
0
Downloads
0
Likes
0
Makes
Fusion file and STL is in the download section.
Bond the 3D-printed guide tube below the drilled hole.
The canister is cut at two places, one at the neck just below the crimp then joined using 2 part epoxy.
A few drops of superglue were poured into the bottom of the can to seal it from possible leakage in the future. (highly unlikely since it's a pressure vessel)
Canister height (where cut is placed from the bottom) 45mm
Canister Diameter 65.70mm
Guide tube length 35mm
Guide tube ID 17mm
If useful, tip: bc1qvew73j9yl7cflzteafa5nr6npxcc0yvwk4jlzv
Bond the 3D-printed guide tube below the drilled hole.
The canister is cut at two places, one at the neck just below the crimp then joined using 2 part epoxy.
A few drops of superglue were poured into the bottom of the can to seal it from possible leakage in the future. (highly unlikely since it's a pressure vessel)
Canister height (where cut is placed from the bottom) 45mm
Canister Diameter 65.70mm
Guide tube length 35mm
Guide tube ID 17mm
If useful, tip: bc1qvew73j9yl7cflzteafa5nr6npxcc0yvwk4jlzv
zerocorebeta veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!