Thingiverse
Spill Proof Oil Can
por zerocorebeta
0
Descargas
0
Likes
0
Makes
Fusion file and STL is in the download section.
Bond the 3D-printed guide tube below the drilled hole.
The canister is cut at two places, one at the neck just below the crimp then joined using 2 part epoxy.
A few drops of superglue were poured into the bottom of the can to seal it from possible leakage in the future. (highly unlikely since it's a pressure vessel)
Canister height (where cut is placed from the bottom) 45mm
Canister Diameter 65.70mm
Guide tube length 35mm
Guide tube ID 17mm
If useful, tip: bc1qvew73j9yl7cflzteafa5nr6npxcc0yvwk4jlzv
Bond the 3D-printed guide tube below the drilled hole.
The canister is cut at two places, one at the neck just below the crimp then joined using 2 part epoxy.
A few drops of superglue were poured into the bottom of the can to seal it from possible leakage in the future. (highly unlikely since it's a pressure vessel)
Canister height (where cut is placed from the bottom) 45mm
Canister Diameter 65.70mm
Guide tube length 35mm
Guide tube ID 17mm
If useful, tip: bc1qvew73j9yl7cflzteafa5nr6npxcc0yvwk4jlzv
zerocorebeta también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!