Split 2 "Screwless" Runcam Camera Mount

I have been designing "Screwless" TPU Camera mounts for a bunch of Runcam cameras.

*Now contains Variants for 30 and 35mm standoffs*

This one is made for the Alien / Martian 2, but should fit any frame with the middle of the standoff holes ~28-29mm apart. I've uploaded two angle variants, 25/30 degrees. The geometry of the split means there might be a small amount of standoff in view with higher-FOV lenses. You can sand these down to suit. I've already made a notch required for the 30 degree variant to work with 150 degree lenses.

This design is currently known to fit with:
- Runcam Split V2
- Runcam Split V1 (Requires a few winds of insulation tape as it's a bit smaller than the V2)

Check out my other things to find variants for other cameras.
________________________________
As the name suggests, you don't need to screw the camera into the mount. All you have to do is pry the mount open a bit, and pop the camera in!

This will fit any frame that uses 35/30mm stando