Thingiverse
Split Blade Sword
door FVDM
14
Downloads
16
Likes
0
Makes
My son saw this split blade used by Elektra in Iron Fist and asked me if I could print one.
This is my first design in Fusion 360 an it was a steep learning curve, but I am happy with the result.
The sword snaps together with eight 6x2mm magnets.
I have used a welding wire to stiffen the blades and foreseen slots, but is does work also without them.
There are a few extra, smaler, slots that can be used to reinforce the joint.
Two pieces can be printed at the same time diagonally on a 300X300 print area.
Total lengt is around 560mm.
The first picture is a GIF file. Expand view and go to original file, than the GIF works.
This is my first design in Fusion 360 an it was a steep learning curve, but I am happy with the result.
The sword snaps together with eight 6x2mm magnets.
I have used a welding wire to stiffen the blades and foreseen slots, but is does work also without them.
There are a few extra, smaler, slots that can be used to reinforce the joint.
Two pieces can be printed at the same time diagonally on a 300X300 print area.
Total lengt is around 560mm.
The first picture is a GIF file. Expand view and go to original file, than the GIF works.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
