Thingiverse
Split-flap display
door snapturtle
20
Downloads
20
Likes
0
Makes
This is my 3d printable version of the DIY Split-Flap Display created by Dave Madison.
For details on electronics and programming, check his [page](https://www.partsnotincluded.com/building-diy-split-flap-displays).
Additional hardware needed per module (Excluding electronics)
* F624ZZ Flanged Ball Bearing **x 1**
* Socket Botton Head Cap Screw M3-8 mm with Nut **x 2** (for Hall sensor)
* Allen Bolt M4 10mm with Nut **x 6** (for connecting all parts)
* Allen Bolt M4 15mm **x 2** (for spool axle and flap stop)
For details on electronics and programming, check his [page](https://www.partsnotincluded.com/building-diy-split-flap-displays).
Additional hardware needed per module (Excluding electronics)
* F624ZZ Flanged Ball Bearing **x 1**
* Socket Botton Head Cap Screw M3-8 mm with Nut **x 2** (for Hall sensor)
* Allen Bolt M4 10mm with Nut **x 6** (for connecting all parts)
* Allen Bolt M4 15mm **x 2** (for spool axle and flap stop)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!