Thingiverse
Sponge caddy
door bwild9009
20
Downloads
12
Likes
0
Makes
Simple sponge caddy for double sink with large divider. Dimension for sink divider is 66.5 mm....
The chamfers are not only for aesthetics but also drying purposes...shouldn't need any supports if you flip the right way;)
Ender 3 pro
Critical Settings:
Layer Height: .3 (lower if preferred but this is what I did)
Infill: 20
Walls: 3
Top/Bottom layers: 4/4
V5 adds chamfers to lower level... if you download v5 your part is actually better than mine!!
The slots on the top layer are slightly offset to favor the left side (or right if flipped around) for my application...hope this is ok for yours!!
The chamfers are not only for aesthetics but also drying purposes...shouldn't need any supports if you flip the right way;)
Ender 3 pro
Critical Settings:
Layer Height: .3 (lower if preferred but this is what I did)
Infill: 20
Walls: 3
Top/Bottom layers: 4/4
V5 adds chamfers to lower level... if you download v5 your part is actually better than mine!!
The slots on the top layer are slightly offset to favor the left side (or right if flipped around) for my application...hope this is ok for yours!!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
