Sponge Extender (Customizable)

***Clean floor and walls of your shower stall without bending over or stretching.***

How to assemble: Add a broomstick of suitable diameter and length (e.g. 100 cm) and clamp your sponge into the holder. A sponge with a rough scrubbing back (see picture) seems best suited.

The supplied .stl files assume a sponge footprint of 70 x 110 mm, a sponge clamping height of 12 mm and a broomstick diameter of 20 mm (plus 0.6 mm over-extrusion into the flange's bore for the broomstick). If this does not fit your sponge or broomstick dimensions, then you may create custom .stl files either in OpenSCAD or via the online Customizer:

- Download the enclosed OpenSCAD source file, open it in OpenSCAD and adapt the x_sponge, y_sponge, z_clamp and d_broomstick parameters at the top and create a customized .stl file. You must have OpenSCAD already installed on your computer or install it now according to the instructions below. Installing OpenSCAD and editing the parameters is not difficult or time-co