MakerWorld
Other House Models
Zum Modell
Sponge Holder
4.4k
Downloads
699
Likes
3.3k
Makes
I have created a Sponge holder V2. Check it out here: https://makerworld.com/en/models/968023#profileId-939093 We needed a place to allow our dish sponge to dry. So… Here it is. I recommend printing this on the back face (shown below) requiring no supports.. I printed this at .2 mm layers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
