Thingiverse
Sponge Holder
by stusona
8
Downloads
7
Likes
0
Makes
Fusion 360 link for editing: http://a360.co/2vk4qIT
Holds a typical sponge at a 45 degree angle.
I put a small incline on the bottom so rocks/marbles would stay towards the back. This helps hold it in place, and makes it a bit fancier.
I made some flat spots on the corners for some silicone non-slip feet to keep it in place and allow air to dry the bottom of it.
Holds a typical sponge at a 45 degree angle.
I put a small incline on the bottom so rocks/marbles would stay towards the back. This helps hold it in place, and makes it a bit fancier.
I made some flat spots on the corners for some silicone non-slip feet to keep it in place and allow air to dry the bottom of it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!