Thingiverse
Sponge Holder
por stusona
8
Descargas
7
Likes
0
Makes
Fusion 360 link for editing: http://a360.co/2vk4qIT
Holds a typical sponge at a 45 degree angle.
I put a small incline on the bottom so rocks/marbles would stay towards the back. This helps hold it in place, and makes it a bit fancier.
I made some flat spots on the corners for some silicone non-slip feet to keep it in place and allow air to dry the bottom of it.
Holds a typical sponge at a 45 degree angle.
I put a small incline on the bottom so rocks/marbles would stay towards the back. This helps hold it in place, and makes it a bit fancier.
I made some flat spots on the corners for some silicone non-slip feet to keep it in place and allow air to dry the bottom of it.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!