Thingiverse
Sponge Holder
von 3Dchill
429
Downloads
304
Likes
0
Makes
A sponge holder for a two-parted sink. The bridge in the middle is 20-25mm, one side of the holder is 40mm wide, the other 60mm and it has a length of 120mm.
The one-sided version can be found here: https://www.thingiverse.com/thing:3936999
The one-sided version can be found here: https://www.thingiverse.com/thing:3936999
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
