Thingiverse
Sponge holder
door gyscos
8
Downloads
8
Likes
0
Makes
This is a rework of dragonboi's [original holder](http://www.thingiverse.com/thing:3359351), but designed to print without support. Just lay the part on its side.
Should work with standard 3cm sink dividers.
OpenSCAD file is included if you want to customize some dimensions.
Should work with standard 3cm sink dividers.
OpenSCAD file is included if you want to customize some dimensions.
gyscos publiceert ook op
27 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!