Thingiverse
Sponge Holder
von Keind23
1
Downloads
2
Likes
0
Makes
Pot fitting on the side of a sink.
A part of the pot is hanging over the sink and is open to let the water drop.
Sink border should be 55mm width and 10mm height.
A part of the pot is hanging over the sink and is open to let the water drop.
Sink border should be 55mm width and 10mm height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!