Thingiverse
sponge holder
por MrJoK3r
37
Descargas
33
Likes
0
Makes
I'm make a sponge holder following the request of my girlfriend.
I'm using suction cup with a hole 6 mm and the maximum dimensions of the suction cup support must be less than 15 mm, the height must not exceed 12 mm.
The distance between two suction cup is 60 mm.
------------------------------------------------------------
For print, I used support only for the hole where my suction cup are holding.
I'm using suction cup with a hole 6 mm and the maximum dimensions of the suction cup support must be less than 15 mm, the height must not exceed 12 mm.
The distance between two suction cup is 60 mm.
------------------------------------------------------------
For print, I used support only for the hole where my suction cup are holding.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
