Thingiverse
Sponge holder
von KagaSaurus69
3
Downloads
5
Likes
0
Makes
Sponge holder for the sink so that it does not drip everywhere. You can use the 4 holes on the wall, hangers or even the tap itself.
I printed it with Cura.
If you print it as it is in the picture then don't need supports.
With ABS it work very well.
I printed it with Cura.
If you print it as it is in the picture then don't need supports.
With ABS it work very well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
