Thingiverse
Sponge holder
by Chunimon
12
Downloads
12
Likes
0
Makes
A holder for a sponge with holes for drying the sponge. The holder is attached to dish stand (diameter 3-6mm). With a lighter, the filament can be bent at the tab on the dish stand.
The support should only be used from a ankle of 60 deg so there will be no support in the holes.
The support should only be used from a ankle of 60 deg so there will be no support in the holes.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
