Thingiverse
Sponge holder
von Chunimon
12
Downloads
12
Likes
0
Makes
A holder for a sponge with holes for drying the sponge. The holder is attached to dish stand (diameter 3-6mm). With a lighter, the filament can be bent at the tab on the dish stand.
The support should only be used from a ankle of 60 deg so there will be no support in the holes.
The support should only be used from a ankle of 60 deg so there will be no support in the holes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
