Thingiverse
Spooky
von mmeye
153
Downloads
133
Likes
1
Makes
These are just some pen work for paths in Pshop and extrudes in 3Dmax...
The base is 3 parts, and i did fit #3 on a 220mm bed! (yes i know i should've went and sized them to be equal but i wanted to move on)
Used Gorilla Super Glue for assembly and is holding nice... \m/
The base is 3 parts, and i did fit #3 on a 220mm bed! (yes i know i should've went and sized them to be equal but i wanted to move on)
Used Gorilla Super Glue for assembly and is holding nice... \m/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
