Thingiverse
Spool expander segment
von MisterC
6
Downloads
6
Likes
0
Makes
A 1/2kg filament spool I've got has a small hub diameter, so the filament supplied was wound quite tight. The back tension was enough for the extruder to pull the spool stand over!
I wanted to reuse the spool for a 50m sample of filament so I decided to make some hub packers. I'm just learning OpenSCAD so this was a useful little exercise. I printed all three segments at once with a brim joining them. I've included the photo of all three because of the optical illusion that they appear to be different.
// UPDATE APRIL 17 //
V2 of program added with code tidied and a hole for holding filament added.
STL for a segment to fit the Rigid.Ink spool also added. This STL should use just under 10m of filament to print.
I find that the last third of filament is often quite tight on the spool, so I like to manually rewind it loosely onto an empty and expanded spool.
I wanted to reuse the spool for a 50m sample of filament so I decided to make some hub packers. I'm just learning OpenSCAD so this was a useful little exercise. I printed all three segments at once with a brim joining them. I've included the photo of all three because of the optical illusion that they appear to be different.
// UPDATE APRIL 17 //
V2 of program added with code tidied and a hole for holding filament added.
STL for a segment to fit the Rigid.Ink spool also added. This STL should use just under 10m of filament to print.
I find that the last third of filament is often quite tight on the spool, so I like to manually rewind it loosely onto an empty and expanded spool.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!