Thingiverse
Spool for Jayo
von DoctorDib
1
Downloads
1
Likes
0
Makes
Why a remix?
This is for the people who decided it'd be a good idea to rip the cardboard sides off, making the original model redundant due to the center piece being too small.
Will it work with other spools?
Measure the internal diameter of your spool hole, if it's 75mm (give or take a mm) then it will fit.
How to use:
- Ensure that you secure your filament before removing anything (I used masking tape to keep the tension)
- Rip one side of the filament off (only rip the side off).
- Insert the longest piece of the model into the hole.
- Rip the remaining cardboard side of the filament.
- Insert the the other model and secure it by locking it in place (rotate them)
This is for the people who decided it'd be a good idea to rip the cardboard sides off, making the original model redundant due to the center piece being too small.
Will it work with other spools?
Measure the internal diameter of your spool hole, if it's 75mm (give or take a mm) then it will fit.
How to use:
- Ensure that you secure your filament before removing anything (I used masking tape to keep the tension)
- Rip one side of the filament off (only rip the side off).
- Insert the longest piece of the model into the hole.
- Rip the remaining cardboard side of the filament.
- Insert the the other model and secure it by locking it in place (rotate them)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
