Thingiverse
Spool Holder
von colatino
15
Downloads
8
Likes
0
Makes
Spool holder that I use on my delta printer with a modified flying extruder.
Snaps to the 20x20 aluminum extrusions
Printed with PETG.
Tested with 1 kg filament spool.
EDIT: The bearings are useless as the spool turns around the horizontal rod just fine.
On each end of the roll goes a bearing like this one https://www.thingiverse.com/thing:2440008.
Snaps to the 20x20 aluminum extrusions
Printed with PETG.
Tested with 1 kg filament spool.
EDIT: The bearings are useless as the spool turns around the horizontal rod just fine.
On each end of the roll goes a bearing like this one https://www.thingiverse.com/thing:2440008.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!