Thingiverse
Spool Holder
von brianor01
17
Downloads
12
Likes
1
Makes
This spool holder can accommodate spools with holes from 25mm to 85mm diameter.
There is a central pivot hole to allow for an 8mm screwed rod.
No bearings necessary and will fit to standard Anet A8 filament screwed rod.
This is a total remix of https://www.thingiverse.com/thing:2067525.
Update 20 February 2018:
Rounded the edges and corners and edges so as not to be so uncomfortable to use.
There is a central pivot hole to allow for an 8mm screwed rod.
No bearings necessary and will fit to standard Anet A8 filament screwed rod.
This is a total remix of https://www.thingiverse.com/thing:2067525.
Update 20 February 2018:
Rounded the edges and corners and edges so as not to be so uncomfortable to use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
