Thingiverse
Spool holder
von krystoff
4
Downloads
3
Likes
0
Makes
This spool holder is designed to take place above the Printrite stand by Fab_ster (thing:1216052), made with 20mm thick board.
Compatible with standard 200mm x 45mm spools, for thicker spools just adapt the axis & clip.
Compatible with standard 200mm x 45mm spools, for thicker spools just adapt the axis & clip.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
