Thingiverse
Spool Holder
por Medo94
1
Descargas
0
Likes
0
Makes
This is a spool holder that I designed.
It has enabled me to run my machine faster without increasing the vibration.
based on the “name” of the parts note the following:
-The name of this part "Inner Part_Spool D=50 L80" means. the inner part in which the actual spool will be connected to has a diameter of 50 mm and a length of 80 mm.
I made few configurations of the inner part, because different manufactures use different spool inner sizes.
Example:
if my spool has an inner diameter of 55mm and a length of 65. I would use an "inner part_spool" that is slightly smaller in diameter and at least 10 mm longer.
disclaimer: if you increase your speed significantly above 100 mm/s then the spool might be able to move this holder, i would suggest not going to that extreme but if you do try to but a small structure in front of the spool holder to prevent it from moving.
All infill was 20%
It has enabled me to run my machine faster without increasing the vibration.
based on the “name” of the parts note the following:
-The name of this part "Inner Part_Spool D=50 L80" means. the inner part in which the actual spool will be connected to has a diameter of 50 mm and a length of 80 mm.
I made few configurations of the inner part, because different manufactures use different spool inner sizes.
Example:
if my spool has an inner diameter of 55mm and a length of 65. I would use an "inner part_spool" that is slightly smaller in diameter and at least 10 mm longer.
disclaimer: if you increase your speed significantly above 100 mm/s then the spool might be able to move this holder, i would suggest not going to that extreme but if you do try to but a small structure in front of the spool holder to prevent it from moving.
All infill was 20%
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
