Thingiverse
Spool Holder
door PhracturedBlue
3
Downloads
1
Likes
0
Makes
This is a very simple spool holder. It uses 1/2" magnets to attach it to a metalic base (the shelf my printer is on).
The rod is a piece of schedule 40 3/4"ID pipe. I don't use a braring of any sort, just rest the spool on the pipe. I've been doingit this way for 6 months now without issue.
The magnets I used were these:
http://www.rare-earth-magnets.com/p-18-nsn0586.aspx
I use a 6-32 1/2" flat-head (countersunk) screw to hold the magents in (though they press fit and that is probably not needed
The rod is a piece of schedule 40 3/4"ID pipe. I don't use a braring of any sort, just rest the spool on the pipe. I've been doingit this way for 6 months now without issue.
The magnets I used were these:
http://www.rare-earth-magnets.com/p-18-nsn0586.aspx
I use a 6-32 1/2" flat-head (countersunk) screw to hold the magents in (though they press fit and that is probably not needed
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!