Thingiverse
Spool holding angle
von Basis
1
Downloads
2
Likes
0
Makes
-need about 2x 1000mm of threaded rod (M12) for vertical use
-need about 1x 1000mm of threaded rod (M8) for horizontal use
-need 4x M12 nuts and 4x washers for M12
-need minimal 4x M8 nuts
-threaded rods (M12) are fixed on a stable plate
-need about 1x 1000mm of threaded rod (M8) for horizontal use
-need 4x M12 nuts and 4x washers for M12
-need minimal 4x M8 nuts
-threaded rods (M12) are fixed on a stable plate
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
