Thingiverse
Spool Hub
von kenwshmt
2
Downloads
1
Likes
0
Makes
I think you are required to design your own spool hub if you have a 3d printer, this one is mine.
It fits 8mm rod; an old mendel shaped desk inbox in my case.
Its a 10 lb roll of filament, so its a wide holed center on the plastic rings on the spool.
The machine can't pull it, you must pre slack before you print.
It fits 8mm rod; an old mendel shaped desk inbox in my case.
Its a 10 lb roll of filament, so its a wide holed center on the plastic rings on the spool.
The machine can't pull it, you must pre slack before you print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!