Thingiverse
Spool Puck (work in progress)
door Kezat
4
Downloads
9
Likes
0
Makes
Universal spool holder. Using 4.5mm BB's as ball bearings.
This is a work in progress, to prevent spool tangles around the base the filament needs a little friction, still trying to come up with a good solution. A short section of tubing should work until then. (see last photo)
This is a work in progress, to prevent spool tangles around the base the filament needs a little friction, still trying to come up with a good solution. A short section of tubing should work until then. (see last photo)
Kezat publiceert ook op
15 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
