Spool Saver

If you vaccuum seal your filament spools, you've probably had an instance or two when the spool “collapses” under the vaccuum pressure. This model is designed to prevent that. There are two versions. The original takes approximately 3.75 hrs to print (on X1C) and uses 125g of filament. The lite version takes approximately 3.25 hrs to print and only uses 95g. The lite version also has a cut out designed in it to allow instances when your filament end is looped through the outer holes in the spool. The lite version prints with no support, but you will get a warning from the slicer that there are floating areas.