Spray Bottle Trigger

I have modified the original to fit a spraybottle with an 8mm mount instead of the original 10mm width.

I tried Printing the original with PETG. However most the part was printed on support due to the Pump Peg legs. The PETG would constantly curl and tear off the bed. I redesigned the part to be printed in two halves and then super glued together. I added a bit of material in the top for better gluing surface area.This worked for me. I also included an STL for the complete object if you have a material better printed on support or resin based printing for a stronger part without glue.
If you have a 10mm width spray bottle you could probably just do the same by printing the original and slice in half with your slicer.